PT-104A

          PT-104A

          分  類:其它

          品  牌:歐米茄

          廠  商:Omega工業測量(中國)

          型  號:PT-104A

          相關行業:

          發布時間:2019-12-19 18:01 瀏覽人數:

          最新產品

          產品詳情
          參數
          包裝
          • Measures Temperature (RTDs), Resistance and Voltage
          • High Accuracy (0.01°C) and Resolution (0.001°C)
          • Powered by USB Port or Power-Over-Ethernet (PoE)
          • For Use with 2, 3 and 4-Wire Pt100 and Pt1000 RTD Sensors

          • The PT-104A is a four-channel, high-resolution temperature dataacquisition module for use with PT100 and PT1000 RTD sensors.It can also be used to measure resistance (375 Ω and 10,000 Ω ranges) and voltage (115 mV or 2.5 V ranges). In PT100/PT1000/resistance mode, the unit uses a four wire circuit. In voltage mode, the input connector can be treated as a differential input with ground, or two single-ended inputs. Both inputs must be 0V or above, thoughit does not matter which input has the highervoltage. For the 115 mV voltage range, the accuracy may vary by 2%,and the temperature coefficient will be 100 ppm/°C.

            Although accurate temperature sensors are widely available, it hasbeen difficult to take advantage of them due to errors caused by themeasuring device. The PT-104A, however, is designed to be inherentlyaccurate. Rather than relying on voltage references (which tend to betemperature sensitive) it uses ‘reference’ resistors which areextremely stable (low temperature coefficient and drift). The exactvalue of each resistor is stored in an EEPROM to provide the ultimatein accuracy (yearly re-calibration is recommended). To achievethe 0.001°C resolution a highlyadvanced ADC is used that can resolve to better than 1 part in 16 million.

            Temperature
            The PT-104A measures temperature using platinum resistancetemperature sensors (RTDs). Both common industry standards (PT100and PT1000) are supported. The unit is compatible with 2, 3 and 4 wiresensors (4 wire PT100 sensors are recommended for accuratemeasurements).

            Resistance
            When measuring resistance, the unit uses a four-wire circuit to give thegreatest possible accuracy. Two resistance ranges are available(0 to 375 Ω and 0 to 10,000 Ω). The unit is calibrated for 0 to 375 ?so this range should be used for accurate measurements.

            Voltage
            For voltage measurements, each input connector can be treated asa differential input with ground, or two single-ended inputs.Both inputs must be zero volts or above, though it does not matterwhich input has the higher voltage. Two voltage ranges are available(0 to 115 mV and 0 to 2500 mV). For the most accuratemeasurements use the 0 to 2500 mV range

            Remote Data Collection
            The new USB/Ethernet interface allows the logger to be used in avariety of situations: USB-only, USBpoweredwith Ethernet data, and Ethernet data with Power-over-Ethernet (PoE). Using the Ethernet interface, the PT-104A can be located anywhere on a LAN or on the internet.

            Power over Ethernet (PoE)
            The PT-104A can obtain its power from the Ethernet port as a PoweredDevice (PD) according to the PoE standard. To use this feature, you mustconnect the unit to Power Sourcing Equipment (PSE) such as a networkswitch, router or power injector that also supports the PoE standard. Anystandard Ethernet cable up to 100 m (about 328') in length can be used.

            Software
            The PT-104A is supplied with Windows Logging and PlayerSoftware. The software will automatically detect which sensor isconnected and will display readings in the correct units. Also supplied is a software development kit (SDK).The SDK contains a range of software drivers and example codethat you can use to write your own software or to use your PT-104Adata logger with third party software. With the included Logging Softwareyou can set the sampling interval from 1 second to several hours andset the maximum number of readings. You can also tell thePT-104A data acquisition module what do to when the temperaturereadings have been taken—either: stop; repeat immediately (startagain); scroll (oldest recordings disappear); or repeat after delay(where the delay is set by the user). Multiple PT-104A modules can beused simultaneously with the logging software. Also, PT-104Amodules can be mixed with TC-08 thermocouple input modules andused at the same time. Up to 20 units of any kind (PT-104A orTC-08) can be connected.Using the PT-104A loggingsoftware, data can be viewed in a spreadsheet and/or in a graph as itis being recorded. Data collected from previous recordings can alsobe viewed using the Player.

            Specifications
            PT-104A Platinum Resistance Data Logger
             TemperatureResistanceVoltage
                SensorPt1001, Pt1000N/AN/A
                Range-200 to 800°C
            (-328 to 1472°F)
            0 to 375 Ω1
            0 to 10 kΩ
            0 to 115 mV
            0 to 2.5V1
                Linearity20 ppm20 ppm20 ppm
                Accuracy @ 25°C0.01°C120 ppm10.2%1
                Temperature
                Coefficient
            5 ppm/°C5 ppm/°C100 ppm/°C
                RMS Noise
                (Using Filter)
            0.01°C10 ppm10 ppm
                Resolution0.001°C1 µ Ω0.156 µV
                Conversion Time
                Per Channel
            720 mS
                Number of Inputs4
                Connectors4-pin mini DIN
                Input Impedance>>1 MΩ
                Overvoltage Protection±30V
                PowerPowered by USB or Ethernet:
            USB 1.1: 5 V ±10% @ <100 mA
            USB 2.0: 5 V ±10% @ <200 mA
            Ethernet: 48 V ±20% @ <40 mA (<2W)
                Environmental20 to 30°C (68 to 86°F) for stated accuracy,
            0 to 70°C (32 to 158°F) operating,
            20 to 90% RH
                SoftwareLogging Software for 32-bit or 64-bit editions of Windows XP
            (SP2 or greater), Vista, 7.
            Software Development Kit containing drivers and example code for C,
            C++, Excel and LabView.
                Ethernet PortConforms to IEEE 802.3 10Base-T.
            Compatible with 10/100/1000Base-T networks.
            Conforms to IEEE 802.3af Power-over-Ethernet (PoE).
                USB PortConforms to USB 2.0 full-speed (12 Mbps)
                Computer InterfaceUSB or Ethernet
                Dimensions36 H x 135 W x 184 mm D (1.42 x 5.31 x 7.24")
                Weight500 g (1.1 lb)
            1 Quoted accuracy is for options marked



















          暫無內容提供
          暫無內容提供

          聯系方式

          中國自動化網安全提示,在購買供應商商品時,請一定要先審核好企業信息是否真實,謹防網上詐騙。
          公司名稱:Omega工業測量(中國)
          聯系人: 王先生
          聯系電話:02161973664
          手機號:
          傳 真:
          電子信箱:kevin.wang@cn.omega.com
          公司網站:http://cn.omega.com
          公司地址:上海市宜山路1698號102單元
          留言反饋
          • 評價:

          • 關于:

          • 聯系人:

          • 聯系電話:

          • 聯系郵箱:

          • 需求意向:

          • 驗證碼:

            看不清楚?

          • 在線咨詢
          主站蜘蛛池模板: 日韩精品无码人妻一区二区三区| 色综合久久天天综合观看| 狠狠综合久久av一区二区| 国产成人精品一区二区三区| igao激情在线视频免费| 日本红怡院亚洲红怡院最新| 亚洲欧美日韩精品专区| 免费看污成人午夜网站| 女人18岁毛片| 亚洲另类激情综合偷自拍图| 黄大片a级免色| 无码h黄肉3d动漫在线观看| 亚洲成人在线电影| 精品久久久无码人妻中文字幕| 国产好爽…又高潮了毛片| 91一区二区视频| 日本黄色片下载| 午夜成人理论福利片| chinese中国农村夫tube| 日本人亚洲人jjzzjjzz页码1| 亚洲国产精品自产在线播放| 豪妇荡乳1一5白玉兰| 夫妇野外交换hd中文小说| 久久久久国产一区二区| 欧美丰满熟妇xx猛交| 亚洲美女精品视频| 精品第一国产综合精品蜜芽| 国产超爽人人爽人人做| 久久综合给合久久狠狠狠97色| 美女福利视频一区| 国产成人一区二区三区视频免费| xyx性爽欧美| 欧美yw193.c㎝在线观看| 免费观看亚洲人成网站| 阿娇被躁120分钟视频| 天堂网2018| 中文字幕免费在线视频| 日韩视频免费看| 亚洲日本va午夜中文字幕一区| 色视频www在线播放国产人成| 国产精品一区二区av不卡|